The salt spray test chamber is widely used in the test, and how to use it is quite familiar for everyone. There are some tricks in the process of using large or small instruments. After understanding these tips, you will get twice the result with half the effort. As a well-known test equipment manufacturer, we have accumulated the experience accumulated over the years to tell you about the small details that need to be paid attention to when using the salt spray test chamber, which can extend the service life of the equipment and protect your health. Satin Fabric,Satin Cloth,Cotton Satin Fabric,Printed Satin Fabric Zhejiang Province Changxing Silk Co.,Ltd , https://www.cx-fabric.com
It is well known that the salt spray test box test mainly uses sodium chloride and purified water (or distilled water, deionized water) to prepare a salt liquid. This salt liquid is very harmful to human body and materials during the experiment, especially in salt spray. When the salt spray is sprayed outward in the corrosion test, it is more prudent. There is no specific need to avoid opening the cover to ensure standard operation.
After the salt spray test chamber has been used, if it is not immediately tested, immediately drain the water from the tank and dry the cabinet to avoid scale formation. Since the jaws of the equipment are often used, it is easy to wear and the small piston will damage the oil after too much oxidation. Therefore, it is better to clean the jaws after each test. Regularly check the screws on the jaws and tighten them if they are loose. Regularly check the transmission of the sprocket. If it is found to be loose, re-tension the tensioner. Pay attention to whether the rear panel of the controller is in good contact. If the test box is not used for a long time, the controller should be turned off. The interface of the controller should be correct. If the connection is wrong, it will cause damage to the equipment.
Any equipment and equipment need to be inspected regularly, and maintenance of the salt spray chamber is often required. As long as you pay attention to these small details in the process of use, it will naturally avoid some equipment failures and improve production efficiency.